Electric Vehicle Chargers for 2 Wheeler - 250W / 350W E-Bike BLDC Motor Controller    
 
Programmable BLDC motor controller provides efficient, smooth and quite control for electric vehicles which operate 36V/48V battery system.
SALIENT FEATURES :
-E- Braking will release the motor from the controller as long as brake is applied.
- Over current protection to protect controller during faulty conditions or short circuit.
- Low voltage detection ensures Battery life.
- Pedal assist mode controls the motor speed based on the speed of peddling.
- Accelerator fault protection to prevent runway.
- Provision for 120°/ 60° Selection.
- Speedometer output.
- Brake inputs with high active and low active provision.
* Speed limit control provision.
SPECIFICATION :
  250 / 350W
Micro Controller based intelligent Available
Embedded control logic software Available
Closed loop control speed / torque Available
MOSFET power device Available
Forward / Reverse – Direction control Available
Continuous power 350W@48V
Peak power 864W@48V
E-ABS braking Available
Settable fail safe protection Available
Natural air cooling system Available
5V DC for motor hall-effect sensors Available
Anodized Chassis mount heat sink Available
Anodized extruded Aluminum heat sink (chassis mount) Available
OPERATING CONDITIONS  
Operating Voltage 36/48V
Continuous current 7.5A
No load current <0.08A
Over current 240% for 1Min Available
Operating temperature 10°C to 50°C
Storage temperature 0°C to 75°C
Humidity 95% RH Non - condensing Available
Motor type Brush Less DC Motor(BLDC)
Rated power 250/350W
Rated voltage 36V/48V
Rated rotation speed 210RPM(Programmable)
Low voltage protection <42V(for 48V Battery
PROTECTIONS  
Maximum load current limitation 18A
Battery low voltage protection Available
Component failure protection Available
Hall sensor failure protection Available
Handle bar protection Available
MOSFET Failure Available
Reverse polarity Available
Short circuit protection Available

 
AEC/MKTG-WEB CAT - BMC - 250W Spec

Copyright ©Axiom Energy Conversion Pvt. Ltd., All Rights Reserved
AXIOM Energy Conversion Pvt. Ltd. 207/4&5, Phase II, IDA, Cherlapally, Hyderabad - 500 051, Andhra Pradesh, India.